Procedure
1.
Loosen (but do not remove) the four rail adjustment screws on each rail, as
shown in Figure 3.
2.
Refer to Figure 4 on page 3. At the front of the rack, position the right-hand rail
in the rack at the appropriate EIA location. Make sure that the two locating
pins seat properly. The bottom of the rail should line up with the bottom EIA
boundary.
Note:
When installed, each EXN4000 will occupy a 3U space.
Right rail
Left rail
Front of rack
Rear of rack
Rail adjustment
screws
Locating pins
exn40002
Figure 3. Installing the rails in the rack
2
Содержание EXN4000
