![background image](http://html1.mh-extra.com/html/ibm/exn4000/exn4000_installation-and-setup-instructions_3853740011.webp)
Using two silver pan head M5 screws, attach the rail to the front of the rack
using holes H3 and H7. Tighten these screws with a screwdriver.
3.
At the rear of the rack, position the rail at the same EIA location used in step 2.
Make sure that the locating pins seat properly. Using two silver pan head M5
screws, attach the rail to the rack using holes H2 and H8. Tighten these screws
with a screwdriver.
4.
Tighten the four rail adjustment screws on the installed rail.
5.
Repeat steps 2 through 4 for the left-hand rail.
6.
Repeat steps 1 through 5 for each additional EXN4000 that you are installing in
the rack, making sure to allow 3U of space for each EXN4000.
Installing the EXN4000 in the rack
Use these instructions to install the EXN4000 in the rack.
Before you begin
18-32 kg (39.7-70.5 lbs)
svc00167
CAUTION:
A fully populated EXN4000 weighs is less than 32 kg (70.5 lbs). Use
two people to lift an EXN4000 into a rack. To make the unit lighter
and easier to move, remove the power supplies and Input/Output
modules (IOMs), noting the location of each component for
reinstallation. Do not remove the disk drives or drive blank covers to
reduce the weight. After the unit is installed in the rack, reinsert the
power supplies and IOMs.
Note:
Verify the shelf IDs before installing into the rack. All shelf IDs should be
correct and sequential in the individual loop(s). If the filer and expansion unit
were configured together by manufacturing, these IDs are already set. The label on
the front should match the switch on the back. For more information, refer to the
EXN4000 Hardware and Service Guide
.
Section of rack EIA rail
H2
H1
H3
H4
H5
H6
H7
H8
H9
Locating pins
Bottom rail screws
REAR
Left and Right
Rails
Chassis attach screws
H2
H1
H3
H4
H5
H6
H7
H8
H9
FRONT
Left and Right
Rails
Top rail screws
Locating pins
Chassis attach screws
1 EIA unit (1U)
Bottom rail screws
Top rail screws
exn40003
Figure 4. Section of rack EIA rail
Installation and setup instructions
3
Содержание EXN4000
