IBM eServer xSeries 305 Type 8673, Руководство пользователя

Страница: 31 / 56

– Configuration
Select this choice to view or change SCSI controller settings. To reset the
controller to its default settings, press F6 and follow the instructions on the
screen.
You can view and change the following controller settings:
- SCSI Controller ID
Select this choice to view the SCSI controller ID, which is typically 7.
- SCSI Controller Parity
This choice is set to Enabled and cannot be changed.
- SCSI Controller Termination
This choice is set to Enabled and cannot be changed.
– Additional Options
Select this choice to view or change the setting for advanced configuration
options. These options include support for large hard disk drives and support
for drives with Ultra SCSI speeds.
- Boot Device Configurations
Select this choice to configure startable-device parameters. You must know
the SCSI ID of the device that you want to configure.
- SCSI Device Configuration
Select this choice to configure SCSI-device parameters. You must know the
SCSI ID of the device that you want to configure.
The sync transfer rate is the transfer rate for Ultra SCSI devices. For Ultra3
SCSI LVD devices, the maximum rate is 160 MBps; for Ultra2 SCSI
devices, 80 MBps; for Fast SCSI devices, 20 MBps.
- Advanced Configurations
Select this choice to reset the SCSI Bus and to display a message during
BIOS initialization.
– BIOS Information
- Interrupt (IRQ) Channel
Select this choice to view the Change Interrupt Request settings.
- I/O Port Address
Select this choice to view the Input/Output ports.
v SCSI Disk Utilities
Select this choice to view the SCSI ID that is assigned to a device or to format a
SCSI device. Select a device from the list and read the instructions on the screen
carefully before making a selection.
Chapter 2. Configuring your server
19