IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 78 / 573

Quick Entry MAP
Quick Entry MAP Table of Contents
Problem Description Page No.
Service actions 59
OK does not appear in the operator panel display before pressing the
power-on button. Other symptoms appear in the operator panel display
or LEDs before the power-on button is pressed. 59
8-digit error codes 60
System stops with an 8-digit number displayed 60
System stops with a 4-digit number displayed that does not begin with 0
or 2. 60
System stops with a 3-digit number displayed (see below for 888
sequence). 60
Hardware Management Console (HMC) Problem 60
There appears to be a display problem (distortion, blurring, etc.) 61
Power and cooling problems 62
888 sequence in operator panel display 62
Other symptoms or problems 62
Attention: If you replace FRUs or perform an action and the problem is still not
corrected, go to “MAP 1540: Minimum Configuration” on page 101 unless you were
directed to MAP 1540 by the error code. Otherwise, call for support if the actions for an
error code do not resolve the problem.
If you replace FRUs or perform an action, and the problem is corrected, go to
″
MAP
0410: Repair Checkout
″
in the RS/6000
Eserver
pSeries Diagnostic Information for
Multiple Bus Systems.
Note: Do not use MAP 0410 to do the repair checkout if the only service actions you
perform are on the HMC.
58 Eserver
pSeries 630 Models 6C4 and 6E4 Service Guide