IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 80 / 573

You have a blank display on the operator panel.
Other LEDs on the operator panel are off. Go to “MAP 1520: Power” on page 91.
8-Digit Error Codes
You have an 8-digit error code displayed Look up the error code in the table in
“Checkpoint and Error Code Index” on
page 155.
System stops with an 8-digit number displayed
The system stops with an 8-digit error code
displayed when booting. Look up the error code in the table in
“Checkpoint and Error Code Index” on
page 155.
System stops with a 4-digit number displayed
The system stops with a 4-digit number
displayed that does not begin with 0 or 2. Go to “Checkpoint and Error Code Index” on
page 155.
If you do not find the error code there, go to the
Fast Path MAP in the
RS/6000
Eserver
pSeries Diagnostic Information for Multiple Bus
Systems
.
System stops with a 3-digit number displayed (see below for 888 sequence)
The system stops with a 3-digit error code. Add 101- to the left of the three digits to create
an SRN. Go to the
RS/6000
Eserver
pSeries
Diagnostic Information for Multiple Bus
Systems
.
If there is a location code displayed under the
3-digit error code, then look at the location to
see if it matches the failing component that the
SRN pointed to. If they do not match, perform
the action from Diagnostic Information for
Multiple Bus System first. If the problem still
exists, then replace the failing component from
that location code.
Hardware Management Console (HMC) Problem
60 Eserver
pSeries 630 Models 6C4 and 6E4 Service Guide