IBM eServer 370 xSeries, Руководство по установке

Страница: 37 / 92

Note: If you are installing a slim-high drive, you must separate the slim filler
bezel from the tray, and insert the slim filler bezel into the top of the
hard disk drive cage. Otherwise, store the filler panel in a safe place.
5. Install the hard disk drive
2
in the hot-swap bay:
a. Remove the new drive assembly from the static-protective package.
b. Touch the static-protective package containing the drive assembly to any
unpainted metal surface on the server. Then, remove the drive assembly
from the static-protective package.
c. If you are installing a slim-high drive, separate the slim filler bezel from the
tray, and insert the slim filler bezel into the top of the hard disk drive cage.
d. Ensure that the tray handle
3
is open (that is, perpendicular to the drive).
e. Align the drive assembly so that it engages the guide rails in the bay.
f. Gently push the drive assembly into the bay until the drive stops.
g. Push the tray handle to the closed (locked) position.
6. Check the hard disk drive status indicators to verify that the hard disk drives
are operating properly. See “Controls and indicators” on page 41 for details.
Notes:
a. The front of each hot-swap hard disk drive has two indicator lights (see
“Controls and indicators” on page 41). If the amber hard disk status light
for a drive is lit continuously, that individual drive is defective and needs to
be replaced. When the hard disk status light indicates a defective drive,
you can replace a hot-swap drive without turning off the server.
b. If your server has a ServeRAID adapter installed, refer to the ServeRAID
adapter documentation for details about configuration requirements.
c. If the hot-swap disk drive bays are not connected to a ServeRAID adapter,
you might need to shut down and restart the server for the drive to be
recognized.
7. If you have other options to install, do so now. Otherwise, go to “Completing
the installation” on page 35.
Chapter 2. Installing options
25