IBM BladeCenter S SAS RAID Controller Module, Инструкция по установке и эксплуатации

Страница: 74 / 216

10 105 Off Masked ArtsTime %<AltString:1=initialized:2=updated> - previous value
was %<TimeDate>
11 110 Off Masked API requested %<AltString:1=ctlr1:2=ctlr2:3=ctlrs 1&2> to
shutdown and %<AltString:1=power off:2=enter service mode>
configure pool
The
configure pool
command allows of user to change the owner controller for a
group from CLI. This command must be run on a survivor controller. The other
controller must be in service mode.
Command arguments:
<CLI> configure pool -name [POOLNAME] -changeowner
-help option
COMMAND-HELP: configure pool
This command is used to change the owner controller for a group from CLI.
This command must be run on a survivor controller. The other controller must be
in service mode.
Usage : configure pool -name [POOLNAME] -changeowner.
POOLNAME : Name of the pool that needs to change the owner controller.
Examples:
<CLI> configure pool -name p1r5 -changeowner
Current Machine Local Time: 02/07/2013
11:04:44 AM
Error : Change pool ownership command failed
Reason: Controller state is not valid for this request
Note: One of controller must be in survivor mode.
<CLI> shutdown -ctlr 1 -state servicemode
Current Machine Local Time: 03/04/2013
01:22:51 PM
Shutdown Command accepted
<CLI>configure pool -name p1r5 -changeowner
Current Machine Local Time: 03/04/2013
01:45:45 PM
Change pool ownership command successful
configure timeout
The
configure timeout
command displays and sets the session timeout for the
command line interface. When the configured timeout period is reached, the
system automatically closes the CLI session.
By default, CLI session timeout is disabled. The minimum timeout period is two
minutes (120 seconds). To disable CLI session timeout after you have configured it,
use the
-set option and specify "00" for HR , MIN , and SEC .
An error appears if you issue the -set option while the list is empty or if the
timeout value is invalid.
Command arguments:
<CLI> configure timeout -[get | set <HR:MIN:SEC> | help]
-help option
64
IBM SAS RAID Controller Module: Installation and User's Guide IBM BladeCenter S SAS RAID Controller Module