IBM BladeCenter HS20, Инструкция по установке и эксплуатации

Страница: 39 / 88

8. To install the DIMMs, repeat the following steps for each DIMM that you install:
a. Turn the DIMM so that the DIMM keys align correctly with the connector on
the system board.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, handle the clips gently.
b. Insert the DIMM by pressing the DIMM along the guides into the connector.
Make sure that the retaining clips snap into the closed positions.
Important: If there is a gap between the DIMM and the retaining clips, the
DIMM has not been correctly installed. In this case, open the retaining clips
and remove the DIMM; then, reinsert the DIMM.
9. If you have other options to install or remove, do so now; otherwise, go to
“Completing the installation” on page 34.
Removing the blade server bezel assembly
To install certain options, you must first remove the blade server bezel assembly.
The following illustration shows how to remove the bezel assembly.
Control panel
connector
Bezel-assembly
release
Bezel-assembly
release
Control-panel
cable
To remove the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on page v and “Installation guidelines” on
page 21.
2. Open the blade server cover (see “Opening the blade server cover” on page 23
for instructions).
3. Press the bezel-assembly release and pull the bezel assembly away from the
blade server approximately 1.2 cm (0.5 inch).
4. Disconnect the control-panel cable from the control-panel connector.
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.
Chapter 3. Installing options
27