IBM BladeCenter Advanced Management Module, Руководство по установке

Страница: 33 / 80

Removing the battery
The management module battery is not a field or customer replaceable item.
When a management module is no longer needed, remove the battery from the
module and recycle or properly dispose of both the management module and
battery according to applicable local and national ordinances or regulations.
(See and “Battery return program” on page 59 for additional information).
To remove the battery, complete the following steps:
1. Read the safety information that begins on page v and the “Installation
guidelines” on page 11.
2. If the management module is installed in a BladeCenter unit, remove it (see
“Removing a management module” on page 15).
3. Open the management module cover by lifting the rear edge.
4. Locate the battery. The battery is typically located on the side of the
management module system board closest to the bezel.
5.
Insert fingertip under the battery and gently lift. The battery should pop
free.
6. If necessary, use a small flat-tip screwdriver to pry the battery loose.
7. Dispose of the battery as required by local ordinances or regulations.
Chapter 3. Installing a management module
23