IBM AS/400e 270, Обновление

Страница: 11 / 26

__ 5. Is there a card other than the 2745 card installed in C07 (270 System Unit) or
C06 (820 System Unit)?
No Yes
↓
Before you remove the card from the system unit, you need to
decide whether you can install the card in a different position. Go to
the
PCI Card Installation Instructions , on the Installation and Service
CD , SK3T-4028, and then return here and continue.
Go to step 6
.
__ 6. DANGER
To prevent a possible electrical shock from touching two surfaces with
different electrical grounds, use one hand, when possible, to connect or
disconnect signal cables. (RSFTD004)
Port 0 is the left connector
, and
port 1 is the right connector
on the 2745
card.
Port 0 is required for Operations Console support. Port 1 is required for
electronic customer support, if you have it.
If you have a cable connected to port 0 (left connector) , disconnect the
cable. If the cable is an electronic customer support cable, connect it to port
1 (right connector) on the same 2745 card.
Notes:
a.
You might have a communications cable already connected to
port 1
(right connector)
. Disconnect the communications cable, to make
port 1
available for the electronic customer support cable. Reconnect the
communications cable to a port on a different 2745 card.
b. Label all cables with the correct card slot and port (for example, C06/port
0 ).
__ 7. Find the operations console cable, part number 97H7557 , and label the
cable, C06/port 0 or C07/port 0 .
__ 8. Connect the operations console cable to the left connector (port 0) on the
2745 card.
__ 9. Connect the other end of the cable to the first available serial port on your
PC that will be used for Operations Console.
__ 10.
Do you have a Remote Control Panel cable to connect?
No Yes
↓
Connect the Remote Control Panel cable to the connector on the
back of the system unit labeled
Debug . Connect the other end of
the Remote Control Panel cable to the parallel port on the back of
the PC being used as the console. Continue with the next step.
__ 11. Install the system unit back cover.
Upgrading Twinaxial Console to Operations Console
5