IBM Aptiva 2178, Справочное руководство

Страница: 120 / 186

Table 1 (Page 2 of 7). POST error codes
Code Description Action
106 System board failure Have the computer serviced.
114 External ROM checksum error If the problem started after
installing an adapter, remove
the adapter and restart the
computer. If the problem
corrects itself, the most likely
cause is the adapter that you
removed. If the problem
persists, have the computer
serviced.
129 Level 1 cache error Have the computer serviced
131 POST detected a system-board
voltage out of range Have the computer serviced
135 Microprocessor fan failure Have the computer serviced
151 Real time clock failure Go to Chapter 4, “Using the
Configuration/Setup Utility
program” on page 27, start the
Configuration/Setup Utility
program, and reset the date
and time. If the problem
persists have the computer
serviced.
161 Defective CMOS Battery Replace the battery. See
“Replacing the battery” on
page 129.
162 A change in device
configuration occurred 1. Verify that all external
devices are turned on.
2. Verify that all devices are
properly installed and
securely connected.
3. If you added, removed, or
changed the location of a
device, you must save the
new configuration in the
Configuration/Setup Utility
program. See “Updating
the computer configuration”
on page 83 and
Chapter 4, “Using the
Configuration/Setup Utility
program” on page 27 for
more information.
98
Aptiva Reference Guide