IBM AMD Opteron LS20 Type 8850, Инструкция по установке и эксплуатации

Страница: 35 / 68

The following illustration shows how to install the second microprocessor on the
system board for the blade server.
Microprocessor
heat sink filler
Microprocessor 1
and heat sink
Heat sink
Microprocessor 2
To install an additional microprocessor, complete the following steps:
1. Read the safety information beginning on page v and “Installation guidelines”
on page 15.
2. Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit. See “Removing the blade server from
the BladeCenter unit” on page 16 for instructions.
3. Carefully lay the blade server on a flat, non-conductive surface.
4. Open the blade server cover (see “Opening the blade server cover” on page
17 for instructions).
5. Remove the bezel assembly (see “Removing the blade server bezel assembly”
on page 18 for instructions).
6. Locate the microprocessor socket on the system board.
7. Unlatch and remove the heat-sink filler.
8. Install the microprocessor:
a. Remove the protective cover, tape, or label from the surface of the
microprocessor socket, if one is present.
Attention: Do not use any tools or sharp objects to lift the locking lever
on the microprocessor socket. Doing so might result in permanent damage
to the system board.
b. Release the microprocessor locking lever by moving it away from the
microprocessor socket and around the locking lever retainer tab; then,
rotate it upward to the fully open position.
Microprocessor-
locking lever
Locking lever
retainer tab
Chapter 3. Installing options
23