IBM AIX HACMP SG24-5131-00, Руководство пользователя по оборудованию

Страница: 149 / 240

© Copyright IBM Corp. 1999
131
Chapter 6. Cluster Testing
Before you start to test the HACMP configuration, you need to guarantee that
your cluster nodes are in a stable state. Check the state of the:
• Devices
• System parameters
• Processes
• Network adapters
• LVM
• Cluster
• Other items such as SP Switch, printers, and SNA configuration
6.1 Node Verification
Here is a series of suggested actions to test the state of a node before
including HACMP in the testing.
6.1.1 Device State
• Run
diag -a
in order to clean up the VPD.
• Look in the errorlog for unusual errors by issuing the command
errpt |
more
or
errpt -a | more
.
• Check that all devices are in the available state (
lsdev -C | more
).
• Check that the SCSI addresses of adapters on shared buses are unique
(
lsattr -E -l ascsi0
).
• If you are using target mode SCSI networks, check the connection by
issuing
cat < /dev/tmscsi#.tm
on the first node and
cat /etc/hosts >
/dev/tmscsi#.im
(enter twice!) on the second node where
#
is the
appropriate tmscsi device number. Repeat the test in the other direction.
Note that cluster services must be stopped on both nodes to perform this
test.
• To check a serial line between two nodes type
stty < /dev/tty#
on both
nodes where
#
is the appropriate tty device number for the RS232
heartbeat connection. Note that cluster services must be stopped on both
nodes to perform this test.