IBM AIX HACMP SG24-5131-00, Руководство пользователя по оборудованию

Страница: 27 / 240

Cluster Planning
9
Much of the decision centers around the following areas:
• Processor capacity
• Application requirements
• Anticipated growth requirements
• I/O slot requirements
These paradigms are certainly not new ones, and are also important
considerations when choosing a processor for a single-system environment.
However, when designing a cluster, you must carefully consider the
requirements of the cluster as a total entity. This includes understanding
system capacity requirements of other nodes in the cluster beyond the
requirements of each system's prescribed normal load. You must consider
the required performance of the solution during and after failover, when a
surviving node has to add the workload of a failed node to its own workload.
For example, in a two node cluster, where applications running on both nodes
are critical to the business, each of the two nodes functions as a backup for
the other, in a mutual takeover configuration. If a node is required to provide
failover support for all the applications on the other node, then its capacity
calculation needs to take that into account. Essentially, the choice of a model
depends on the requirements of highly available applications, not only in
terms of CPU cycles, but also of memory and possibly disk space.
Approximately 50 MB of disk storage is required for full installation of the
HACMP software.
A major consideration in the selection of models will be the number of I/O
expansion slots they provide. The model selected must have enough slots to
house the components required to remove single points of failure (SPOFs)
and provide the desired level of availability. A single point of failure is defined
as any single component in a cluster whose failure would cause a service to
become unavailable to end users. The more single points of failure you can
eliminate, the higher your level of availability will be. Typically, you need to
consider the number of slots required to support network adapters and disk
I/O adapters. Your slot configuration must provide for at least two network
adapters to provide adapter redundancy for one service network. If your
system needs to be able to take over an IP address for more than one other
system in the cluster at a time, you will want to configure more standby
network adapters. A node can have up to seven standby adapters for each
network it connects to. Again, if that is your requirement, you will need to
select models as nodes where the number of slots will accomodate the
requirement.