IBM 9503DG1 - T 221 - 22.2" LCD Monitor, Руководство пользователя

Страница: 23 / 43

Chapter 3. Adjusting and maintaining your monitor 17
Disconnecting the cables
Note:
Before you begin the procedures below, be sure to read the Danger
Statements on page iii.
To disconnect the digital signal cable, do the following:
1. Power off your monitor, peripheral units (if any), and personal
computer or workstation and unplug them from the power outlet.
2. Turn the monitor face down (refer to page 4).
3. Remove the stand rear cover and the connector cover (refer to page
4 and 5).
4. Unhook the cables from the cable clamps and cable hook (refer to
page 5).
5. Lift up the cables and take out the connector tool from the rear
compartment of the monitor (refer to page 5).
6. Disconnect the power adapter cord from the DC-IN connector (refer to
page 6).
Note:
Be sure to press the latch on the connector of the power
adapter cord when unplugging it from the DC-IN connector.
7. Insert the connector tool into the thumb screw on the digital signal
cable connector A and turn it counterclockwise to loosen the
screw.
8. Disconnect the digital signal cable A from video connector A .
3
2
2
Note:
The video connectors A and B on the monitor are Safety Extra
Low Voltage (SELV) circuits.
9. Store the connector tool back into the rear compartment of the
monitor.
Connector tool
Video connector
DC-IN connector