IBM 8678, Инструкция по установке и эксплуатации, Страница: 47 / 96

The following illustration shows how to close the blade server cover.
Blade-cover
release
Blade-cover
release
Cover
pins
Complete the following steps to close the blade server cover:
1. Review the information in “Safety” beginning on page v and “Installation
guidelines” on page 15.
2. If you removed the blade bezel assembly, replace it now. See “Installing the
blade server bezel assembly” on page 32 for instructions.
3. Lower the cover so that the slots at the rear slide down onto the pins at the rear
of the blade server, as shown in the illustration. Before closing the cover, check
that all components are installed and seated correctly and that you have not left
loose tools or parts inside the blade server.
4. Pivot the cover to the closed position as shown in the illustration, until it clicks
into place.
Installing the blade server in the BladeCenter unit
Chapter 3. Installing options
33