IBM 8678, Инструкция по установке и эксплуатации, Страница: 42 / 96

The following illustration shows how to install a SCSI hot-swap hard disk drive.
Filler
panel
Drive tray
Drive handle
(in open position)
Storage
expansion unit
Blade
Hard disk drive
Hard disk drive
status LED
Hard disk drive
activity LED
Complete the following steps to install a drive in a storage expansion unit.
Attention: To maintain proper system cooling, do not operate the BladeCenter
unit for more than one minute without either a drive or a filler panel installed in each
storage expansion unit bay.
1. Review the information in “Safety” beginning on page v and “Installation
guidelines” on page 15.
2. Remove the filler panel from one of the empty hot-swap bays by inserting your
finger into the depression at the top of the filler panel and pulling it away from
the expansion unit.
3. Install the hard disk drive:
a. Ensure that the tray handle is open (that is, perpendicular to the drive).
b. Align the drive assembly with the guide rails in the bay.
c. Gently push the drive assembly into the bay until the drive stops.
d. Push the tray handle to the closed (locked) position.
e. Check the hard disk drive LEDs to verify that the hard disk drive is operating
properly.
v If the amber hard disk drive status LED for a drive is lit continuously, that
drive is faulty and needs to be replaced.
v
If the green hard disk drive activity LED is flashing, the drive is being
accessed.
See the documentation that comes with the expansion unit for information about
configuring the expansion unit and SCSI hard disk drives.
Replacing a SCSI hot-swap hard disk drive
If a hard disk drive in the storage expansion unit fails, you can replace it without
turning off the blade server.
28
BladeCenter HS20 Type 8678: Installation and User’s Guide