IBM 8248-L4T, Руководство пользователя

Страница: 29 / 214

Installing a disk drive or solid-state drive in the 8248-L4T, 8408-E8D, or
9109-RMD system or expansion unit
Complete the following steps to install a disk drive or solid-state drive in a system or in an expansion
unit:
1. If the slot you want to use contains a disk drive filler, remove the disk drive filler from the slot. For
instructions, see “Removing a disk drive filler from the 8248-L4T, 8408-E8D, or 9109-RMD” on page
75.
2. If the drive you are installing does not have a bezel preinstalled, then complete the tasks to install a
bezel on the drive, then continue with this procedure from step 3. For instructions to install a bezel,
see “Installing a disk drive bezel in a disk drive or filler” on page 80.
3. Unlock the drive handle ( A ) by squeezing it and pulling it out toward you. If the handle is not all the
way out, the drive does not slide into the system or expansion unit.
4.
Hold the drive by the top and bottom edges as you position the drive, and insert it into the system or
the expansion unit.
Note: Do not hold the drive only by the handle. Support the drive by holding the drive by its sides.
5. Slide the drive halfway into the system or expansion unit.
6. On the Verify Device Concurrent Add display, verify that the selected drive is the drive you want to
install, then press Enter.
7. When the identify LED flashes, slide the drive all the way into the system or an expansion unit, and
push the drive handle
(A) in until it locks. See Figure 5 showing installing a drive in the system.
8. On the console, press Enter to indicate that you have installed the drive.
9. If you are installing more than one disk drive or solid-state drive, repeat the steps in this procedure
until all disk drives or solid-state drives are installed.
Figure 5. Installing the drive in the system
Installing a disk drive or solid-state drive
13