IBM 808521U, Руководство пользователя

Страница: 89 / 116

The battery normally requires no charging or maintenance throughout its life;
however, no battery lasts forever. If the battery fails, the date, time, and
configuration information (including passwords) are lost. An error message is
displayed when you turn on the computer.
Refer to “Lithium battery notice” on page x for information about replacing and
disposing of the battery.
To change the battery:
1. Turn off the computer and all attached devices.
2.
Remove the cover. See “Removing the cover” on page 60.
3. Locate the battery. See “Identifying parts on the system board” on page 61.
4.
If necessary, remove any adapters that impede access to the battery. See
“Installing adapters” on page 63 for more information.
5. Remove the old battery.
6. Install the new battery.
7.
Replace any adapters that were removed to gain access to the battery. See
“Installing adapters” on page 63 for instructions for replacing adapters.
8. Replace the cover, and plug in the power cord. See “Replacing the cover and
connecting the cables” on page 74.
Note: When the computer is turned on for the first time after battery
replacement, an error message might be displayed. This is normal after
replacing the battery.
9. Turn on the computer and all attached devices.
10.
Use the IBM Setup Utility program to set the date and time and any
passwords. See Chapter 4, “Using the IBM Setup Utility program,” on page 77.
Erasing a lost or forgotten password (clearing CMOS)
This section applies to lost or forgotten passwords. For more information about
lost or forgotten passwords, see Access IBM on your desktop.
To erase a forgotten password:
1. Turn off the computer and all attached devices.
2. Remove the cover. See “Removing the cover” on page 60.
Chapter 3. Types 8084, 8085, 8147, 8148, and 8179
73