IBM 689912U - IntelliStation Z - Pro 6899, Руководство по техническому обслуживанию аппаратной части

Страница: 246 / 472

Correcting Disk Errors from DOS
To run the CHECKDSK program from DOS:
1. Close all active programs, including Windows.
2. At the DOS command prompt type
CHKDSK /F
and
press Enter.
The program will check the hard disk and correct any
errors found.
Correcting Disk Errors from the DOS
Diskette
If you cannot get to a DOS command prompt from your
hard disk, use the following procedure.
1. Insert PC DOS Disk 1 in your diskette drive.
2. Power-on the computer. If the computer is already
on, restart the computer using the Ctrl
+
Alt
+
Del key
sequence.
3. When the following prompt appears:
Do you want to install PC DOS 7 (Y,N)?
type
N
. The command prompt appears.
4. Type
COPY C:\CONFIG.SYS CONFIG.OLD
and press
Enter. This copies your current CONFIG.SYS file as
CONFIG.OLD in case you need it for future reference.
5. At the DOS command prompt type
CHKDSK /F
and
press Enter.
Correcting Disk Errors from OS/2 Warp
When you use the CHKDSK /F command, you cannot
have any other activity on that disk. Therefore, if you need
to use the CHKDSK /F command on the disk where OS/2
is installed, you must shut down OS/2 and use the OS/2
Warp Utility Diskettes.
To correct disk errors on the disk where OS/2 Warp is
installed:
1. Shut down OS/2.
2. Insert
Utility Diskette 1 in your diskette drive.
3. Power-on your computer. If the computer is already
on, restart it using the Ctrl
+
Alt
+
Del key sequence.
4. Follow the instructions on the screen until you get to
a command prompt.
5. Insert
Utility Diskette 3.
6. Type
CHKDSK C:/F:2
; then press Enter. (C is the
drive on which OS/2 is installed.)
7. Follow any instructions that appear on the screen.
8. Remove the diskette from drive A.
9. Restart your computer using the Ctrl
+
Alt
+
Del key
sequence.
To correct disk errors on another drive:
1. On the Desktop, double-click on OS/2 System.
2. Double-click on Command Prompts.
236
IBM PC 300/700, IntelliStation Series HMM