IBM 6400 - Model 008 B/W Line-matrix Printer, Руководство оператора

Страница: 100 / 112

86 Operator’s Guide
A timeout message is sent to the host if
no paper motion has occurred for 10
minutes after Stop was pressed to clear
the jam fault. Clear paper jam and reload
paper. See page 72 for procedure.
Occurs 5 seconds after the ribbon stall
message if the error is not cleared.
Occurs 5 seconds after the stacker jam
message if the error is not cleared.
Occurs 5 seconds after the stacker full
message if the error is not cleared.
Occurs 5 seconds after the stacker fault
message if the error is not cleared.
Host sends data after the printer buffer is
full. (Serial interface) Check printer serial
port configuration setup. Ensure that it
matches host settings.
This custom set does not exist. Define
and save it. (Refer to the Setup Guide.)
Custom set is write-protected. Delete
existing set, then save new set. (Refer to
the Setup Guide.)
Fatal firmware error on the controller
board. Contact an IBM service
representative.
032 FORMS JAMMED TIMEOUT
CLEAR JAM AND RELOAD FORMS
034 RIBBON STALL TIMEOUT
CHECK RIBBON
037 STACKER JAM TIMEOUT
CHECK STACKER
038 STACKER FULL TIMEOUT
CHECK STACKER
039 STACKER FAULT TIMEOUT
CHECK STACKER
041 BUFFER OVERFLOW
042 CUSTOM SET DOES NOT EXIST
SAVE FIRST
043 CUSTOM SET ALREADY EXISTS
DELETE FIRST
044 EC FIRMWARE/HARDWARE ERROR