IBM 5710, Инструкция по установке и использованию

Страница: 50 / 52

Signal Name Connector Signal Name
Ground +C/D 28 62 -C/D
Ground +REQ 29 63 -REQ
Ground +I/O 30 64 -I/O
Ground +DB(8) 31 65 -DB(8)
Ground +DB(9) 32 66 -DB(9)
Ground +DB(10) 33 67 -DB(10)
Ground +DB(11) 34 68 -DB(11)
Note:
v 8-bit SE devices that connect to the P-cable should tie the following signals inactive high: –DB(8), –DB(9),
–DB(10), –DB(11), –DB(12), –DB(13), –DB(14), –DB(15), –DB(P1), and float the same signal lines.
v
8-bit LVD devices or SE mode, the following signals must be tied inactive (+ = inactive low, – = inactive high):
+/–DB(8), +/–DB(9), +/–DB(10), +/–DB(11), +/–DB(12), +/–DB(13), +/–DB(14), +/–DB(15), +/–DB(P1). Floating
these signals is not sufficient.
v All other signals shall be connected as defined.
38
PCI-X Dual Channel Ultra320 SCSI Adapter Installation and Using Guide