IBM 4560SLX, Руководство пользователя

Страница: 85 / 128

11. Replace drive 2 or the blank cover to all modules. If replacing a drive, repeat
the procedure below for each module.
a.
Fully support the drive shoe assembly while starting it into the receiver,
being careful not to damage the drive load handle.
b. Push the drive shoe assembly slowly into the receiver until it seats against
the back of the library.
c. Tighten the two captive retainer screws to secure the module to the library.
d. Repeat for all modules. See “Module configuration” on page 82.
Cartridge elevator extension assembly
This section provides information on cartridge elevator extension components and
assembly.
Components
The cartridge elevator is made up of the following components:
v
Primary chassis (10U length)
v Media elevator car
v
PCB
v Belt block and brackets
v
Drive belt
v Drive motor
v
Drive motor pulley
v
Belt tensioner ramp and idler pulley
v Standoff
v
Motor cable
The cartridge elevator extension contains the following components:
v 5U extension
Figure 68. Cartridge elevator (two units) installed
Appendix B. Adding a library module
75
Get other manuals https://www.bkmanuals.com