IBM 4002-C4A, Инструкция по установке и эксплуатации

Страница: 78 / 94

NetIron(config)# interface ethernet 3/1
NetIron(config-if-e1000-1/1)# no ip add 10.10.10.1/24
NetIron(config-if-e1000-1/1)# ip add 10.10.10.69/24
NetIron-if-e1000-1/1)
v Always use the end command at the end of the file. The end command must
appear on the last line of the file, by itself.
Loading the configuration information into the running-config
You can load the configuration information from a TFTP server. To load the file from
a TFTP server, use either of the following commands:
v copy tftp running-config <ip-addr> <filename> [ overwrite ]
v ncopy tftp <ip-addr> <filename> running-config
Using SNMP to save and load configuration information
You can use an SNMP management application such as Brocade’s IronView
Network Manager or any third-party SNMP management application to save and
load a B48C and B50C switch configuration. To save and load configuration
information using such an SNMP management application, use the following
procedure.
1. Enable the SNMP agent on the switch using the following command from the
global CONFIG level of the CLI:
snmp-server
2. On the switch, enter the following command from the global CONFIG level of
the CLI:
no snmp-server pw-check
This command disables password checking for SNMP set requests. If a
third-party SNMP management application does not add a password to the
password field when it sends SNMP set requests to the switch, by default the
switch rejects the request.
3. From a management station, send the following SNMP PDU to the agent:
SnmpSet (1.3.6.1.4.1.1191.1.1.2.1.5.0 = <TFTP IP address>
1.3.6.1.4.1.1991.1.1.2.1.8.0 = <config-file-name>
1.3.6.1.4.1.1991.1.1.2.1.9.0 = <command-integer>
where:
v <tftp-ip-addr> is the TFTP server’s IP address.
v <config-file-name> is the configuration file name.
v <command-integer> is one of the following:
– 20 - Upload the startup-config file from the device’s code flash to the
TFTP server.
– 21 - Download a startup-config file from a TFTP server to the device’s
code flash.
– 22 - Upload the running-config from the device’s code flash to the TFTP
server.
– 23 - Download a configuration file from a TFTP server into the device’s
running-config.
– 30 - Download the config to DRAM from a TFTP server, clear the
running-running config, and overwrite with the new config.
Note: Command option 23 adds configuration information to the running-config
on the device, and does not replace commands. If you want to replace
configuration information in the device, use ”no“ forms of the
54
IBM Ethernet Switch c-series Installation and User Guide