IBM 300 Series 6268, Руководство по техническому обслуживанию аппаратной части

Страница: 255 / 450

Setup Utility program
Attention
A customized setup configuration (other than default
settings) might exist on the computer you are
servicing. Running the Setup Utility program might
alter those settings. Note the current configuration
settings and verify that the settings are in place when
service is complete. To start the Setup Utility
program, see “Setup Utility program.”
The Setup Utility (configuration) program is stored in the
permanent memory of the computer. This program
includes settings for the following:
Ÿ
System Summary
Ÿ
Product Data
Ÿ
Devices and I/O Ports
Ÿ
Start Options
Ÿ
Date and Time
Ÿ
System Security
Ÿ
Advanced Setup
Ÿ
ISA Legacy Resources
Ÿ
Power Management
To run the Setup Utility program, do the following:
1. Power-off the computer and wait for a few seconds
until all in-use lights go off.
2. Power-on the computer.
3. When the Setup Utility prompt appears on the screen
during start-up, press F1. The Setup Utility menu
appears.
4. Follow the instructions on the screen.
5. When finished, select System Summary to verify that
any configuration changes have been accepted.
Hard disk drive boot error
A hard disk drive boot error (error codes 1962 and
I999030X) can be caused by the following:
Cause Actions
The start-up drive is not in
the boot sequence in
configuration. Check the configuration and
ensure the start-up drive is
in the boot sequence.
No operating system
installed on the boot drive. Install an operating system
on the boot drive.
PC 300 - 6565
245