2006 Model L10 Storage Switch
4
5. Install the switch in the rack (see Figure 2).
a. Carefully slide the switch into the tray assembly
until the slot in the switch’s
port end aligns with the metal tab at the front of the tray. There are two metal tabs
available – one for each switch.
b. Align the metal tab with the slot in the switch’s port end and continue sliding the
switch into the tray until the metal tab is inserted in the slot.
c. Insert the stop bracket’s
metal tab into the slot on the outer side of the switch.
d. Pivot the stop bracket until the stop bracket lays flat against the equipment rack’s
front rail (see Figure 2).
e. Align the stop bracket with the center hole in the equipment rack’s front rail.
f. Attach the stop bracket to the equipment rack’s front rail using one hex screw
.
g. If you are installing two switches into the tray, repeat steps 5a through 5e for the
remaining switch.
Figure 2. Installing the Model L10 switch in the tray assembly
l10
0039
1
6
5
