IBM 2254, Руководство по техническому обслуживанию аппаратной части

Страница: 211 / 252

– Standby: Screen is blank, but can be restored immediately when any activity
is detected.
– Suspend: Monitor uses less power than in Standby mode. Screen image is
restored after a few seconds when any activity is detected.
– Off: Monitor power is off. Press Monitor power button to restore power. On
some monitors, you might have to depress the power button twice.
Setting Automatic Hardware Power Management features
1. Start the Configuration/Setup Utility program (see “Setup Utility program” on
page 10).
2.
Select
Advanced Power Management
from the Configuration/Setup Utility
program menu.
3. Select the APM BIOS Mode and be sure it is set to Enabled . If it is not, press
Left Arrow (
}
) or Right Arrow (Æ) to change the setting.
4.
Select Automatic Hardware Power Management .
5. Set Automatic Hardware Power Management to Enabled .
6. Select values for the three categories of power management (system power,
processor speed, and display), as necessary.
7. Set Hard Disk to Enabled or Disabled .
Note: This does not apply to SCSI drives.
8. Press Esc twice to return to the Configuration/Setup Utility program menu.
9.
Before you exit from the program, select
Save Settings
from the
Configuration/Setup Utility program menu.
10. To exit from the Configuration/Setup Utility program, press Esc and follow
the instructions on the screen.
Automatic Power-On features
The Automatic Power-On features within the Power Management menu allow you
to enable and disable features that turn on the computer automatically.
v
Serial Port A Ring Detect : With this feature set to Enabled and an external
modem connected to serial port (COM1), the computer will turn on
automatically when a ring is detected on the modem.
v
PCI Modem Ring Detect
: With this feature set to
Enabled
, the computer will
turn on automatically when a ring is detected on the internal modem.
v
PCI Wake Up: This feature allow PCI cards that support this capability to wake
the system.
v
Wake Up on Alarm : You can specify a date and time at which the computer will
be turned on automatically. This can be either a single event or a daily event.
v
Wake on LAN : If the computer has a properly configured token-ring or Ethernet
LAN adapter card that is Wake on LAN-enabled and there is remote network
management software, you can use the IBM-developed Wake on LAN feature.
When you set Wake on LAN to
Enabled , the computer will turn on when it
receives a specific signal from another computer on the local area network
(LAN). For further information, see “Wake on LAN” on page 205.
Chapter 8. Additional Service Information
203