IBM 2145-4F2, Руководство по установке

Страница: 81 / 143

1
Assembly wing nuts
2
Hold-down bracket
3
Wing nut
4. Position the rear, hold-down bracket
2
towards the end of the rail
assemblies and tighten the wing nut
3
. See Figure 26.
5. Select the holes in the rail where you want to position the 2145 UPS-1U.
Note: The bottom flange of the support rail must align with the EIA mark on
the rack.
6.
Using two M6
×
10 screws (
1
in Figure 27) and two clip nuts
2
, attach the
rail to the rear of the rack.
7.
Attach only the bottom hole of the rail to the front of the rack with one M6
×
10 screw and one clip nut (see
1
in Figure 28 on page 52).
1
2
3
Front
Rear
svc00033
Figure 26. Adjusting the rail depth on the 2145 UPS-1U
1
2
svc00034
Figure 27. Securing the rear rail on the 2145 UPS-1U
Chapter 4. Installing the UPS, the master console, and the SAN Volume Controller
51