IBM 2104 DL1, Руководство по установке

Страница: 42 / 68

The cron requires a script. To create this script, generate a file named
run_ses_healthcheck in directory /usr/lpp/diagnostics/bin. The contents of the file must
be:
#!/bin/ksh
#Name: run_ses_healthcheck
#Location: /usr/lpp/diagnostics/bin
#Function: SCSI SES hourly healthcheck
/usr/sbin/lsdev -Cc container -t ses -s scsi -F name -S available |
/usr/bin/xargs -n1 -i /bin/nice --10 /usr/lpp/diagnostics/bin/diagela -t {}
Note: Although, because of page width, the final line of the contents is shown here
split between two lines, you must enter it all on one line.
Give the following command so that the script can be run:
chmod 544 /usr/lpp/diagnostics/bin/run_ses_healthcheck
Configuring a 2104 to the using system
Use the cfgmgr command to configure or reconfigure a 2104 to the using system.
Unconfiguring a 2104 from the using system
To remove a 2104 from the using system, use the following command:
rmdev -l [enclosurenumber] -d
where [enclosurenumber] is the enclosure device that was generated by the cfgmgr
command (for example, [ses0], [ses1], [ses2]).
Remove the ses_healthcheck job from the system cron table.
Web Support Page
You can find the web support page at:
http://www.rs6000.ibm.com/support/
Related Publications
v
Diagnostic Information for Micro Channel Bus Systems, SA23-2765
v Diagnostic Information for Multiple Bus Systems, SA38-0509
v Site and Hardware Planning Information, SA38-0508
v Adapters, Devices and Cable Information for Micro Channel Bus Systems,
SA23-2764
28
IBM Expandable Storage Plus: 2104 Model DL1 Installation Guide