IBM 2104 DL1, Руководство по установке

Страница: 31 / 68

5. Refer to Figure 11.
6. While continuing to push the disk drive module into the slot, slowly close the
handle
1
until it stops with a click. This action pushes the module fully home.
7. Verify that the disk drive module that you have just installed is aligned with the
sides of the 2104 and that no gap exists between this module and the modules
that are next to it.
Verify also that the front edge of this disk drive module aligns with the front edges
of the modules that are next to it.
If the disk drive module is not correctly aligned, remove it (see “Removing the Disk
Drive Modules and Dummy Disk Drive Modules” on page 8) and reinstall it (steps 2
through 6 above).
8. Repeat steps 2 through 7 for each disk drive module.
Attention: Any slot that has no disk drive module installed must contain a dummy
disk drive module. The dummy disk drive module ensures that the correct airflow is
maintained around the disk drive modules in the other slots.
Figure 11. Closing the Handle of a Disk Drive Module
Installing a 2104 Model DL1
17