IBM 2073-700, Быстрое руководство по установке

Страница: 40 / 82

This task assumes that your initial planning has determined where the Ethernet
cables are to be located. The Storwize V7000 Unified control enclosures require at
least one and a maximum of two 1 Gbps Ethernet connections. Refer to Figure 34
and Table 2. For the file modules, the first two 1 Gbps Ethernet ports are used for
internal communications between the file modules. The third and fourth 1 Gbps
Ethernet ports are used for management and data (if needed). All 10 Gbps Ethernet
ports are dedicated to data. Management cannot be performed over the 10 Gbps
Ethernet. Refer to Figure 35 and Table 3 on page 31.
Table 2. Ethernet connections available with the control enclosure
Item Port Purpose
IP address is
assigned by
InitTool
Use
E1 Built-in Ethernet
port 1 1 Gbps external
network
connection Yes Management
and service port
for each canister,
optional iSCSI
E2 Built-in Ethernet
port 2 1 Gbps external
network
connection No Optional
management
and service port,
optional iSCSI
Not shown Ethernet port 3
on a 2076-312 or
2076-324 10 GbE external
network
connection No Optional iSCSI
Not shown Ethernet port 4
on a 2076-312 or
2076-324 10 GbE external
network
connection No Optional iSCSI
E1 E2 H1 H2 H3 H4
D1 D2
Top Canister
E1 E2 H1 H2 H3 H4
D1 D2
Bottom Canister
Legend
1G Ethernet
6G SAS
8G FC
10G Ethernet
ifs00012
Figure 34. Control enclosure Ethernet network connections. This diagram is conceptual, not a
physical representation.
S1-Free
S2-FC
iBMC E3 E4 E1 E2 U1 U2
PS1 PS2
S3-Free
S4-10GbE
V7000 File Module #1
(Lower)
2 1
1 2
S1-Free
S2-FC
iBMC E3 E4 E1 E2 U1 U2
PS1 PS2
S3-Free
S4-10GbE
V7000 File Module #2
(Upper)
2 1
1 2
Legend
1G Ethernet
6G SAS
8G FC
10G Ethernet
ifs00013
Video Serial Video Serial
Figure 35. File module node Ethernet network connections. This is a logical diagram of the
connectivity and does not reflect the exact physical system.
30
Storwize V7000 Unified: Quick Installation Guide