IBM 10/100 Ethernet Mini-PCI Adapter, Руководство пользователя

Страница: 16 / 55

For Windows NT
8
Click OK.
9
Follow the instructions on the screen. When you are prompted to point Windows
NT files, specify
C:\I386
10
When the adapter is listed in the “Network Adapter,” click Close.
11
When you are prompted, restart your system. You have installed the driver.
12
Click the Adapters tab.
13
Click Add.
14
Insert the drivers CD-ROM, and click Have Disk...
15
Specify
x:\ETHERNET
, where
x
is the drive letter of the CD-ROM drive, and click
OK.
16
Click OK.
17
Click Close to finish.
18
When you are prompted, restart your system.
Hint
If Windows NT reports an error, or you can't connect to the network, do as follows:
Make sure that you're using the drivers that are on the driver CD shipped with
the Combo card.
Make sure that the driver is loaded and the protocols are bound. Check the
Settings in the Control Panel's “Network/Bindings” dialog box.
Check the Windows NT Event Viewer for error messages.
If you are attaching to a NetWare network, check your frame type and verify that
NetWare client or server software has been installed.
Ask your LAN administrator whether you need to install supplemental
networking software.
If the problem persists, go to “Troubleshooting” on page 7.
To install the Ethernet Power Management driver for Windows NT, do as follows:
1
Start Windows NT.
2
Open Control Panel, and then Network.
3
Click the Protocols tab, and click Add...
4
Insert the drivers CD-ROM, and click Have Disk.
5
Specify
x:\ETHERNET\NPMINT4
, and click OK.
6
Click OK.
7
Click Close.
6