IBM 10/100 EtherJet CardBus Adapter, Инструкция по установке и планированию

Страница: 46 / 64

4-8 10/100 EtherJet CardBus Adapter
NOPREFETCH disables prefetching in memory-mapped I/O
mode by turning off this capability on the CardBus bridge. Using
this keyword could negatively impact performance.
NOWRITEPOST disables prefetching in memory-mapped I/O
mode by turning off this capability on the CardBus bridge. Using
this keyword could negatively impact performance.
PCIIRQ forces the driver to use PCI IRQ routing. Some CardBus
bridges have the capability of supporting both PCI and ISA style
IRQ routing. The driver automatically determines the best choice
for this option unless this keyword is used as an override.
PORT (ODI driver) see IOADDRESS.
RXBUFFERSIZE sets size of the adapter receive packet buffer.
This is a number in decimal in the range 1 - 30 for 16-bit drivers
and 1 - 100 for the 32-bit ODI driver. Each packet adds approxi-
mately 1520 bytes to the resident size of the driver. The default is
15 packets.
SINT (Packet Driver) is a number from hexadecimal 60 to 80 des-
ignating a software interrupt. Default is 60.
SOCKET (16-bit DOS Drivers) identifies number of host com-
puter PC Card slot into which the IBM CardBus adapter is
inserted. If a socket number is specified, only the specified socket
is checked for the IBM adapter. If no socket is specified, all sock-
ets are searched until the IBM adapter is found.
SOCKET (For 32-bit NDIS3 Driver IBMC.SYS) identifies the num-
ber of the host computer's PC slot or socket into which the Ether-
Jet CardBus Adapter is inserted. Valid parameters are
AutoDetect, 1, 2, 3, and 4. If a socket number is specified, only
the specified socket is checked for the EtherJet CardBus Adapter.
The default keyword is AutoDetect, and the driver automatically
checks all slots for the EtherJet CardBus Adapter.
TXBUFFERSIZE sets the size of the adapter transmit packet
buffer. This is the number of transmit packets in decimal in the
range 1 - 10 for 16-bit drivers and 1 - 100 for the 32-bit ODI driver.
Each packet adds approximately 1520 bytes to the resident size
of the driver. The default is 2 packets.
VERBOSE displays additional configuration information when the
driver loads, including information about the CardBus controller
on the PCI to CardBus bridge on the host computer.
fcp1mst.book Page 8 Wednesday, June 2, 1999 4:02 PM