© Copyright LOTRONIC 2013
LAS-S130RG-MULTI
3
SAFETY RECOMMENDATIONS
•
INSTALL THE UNIT IN SUCH A WAY THAT NOBODY CAN STARE
INTO THE LASER BEAM.
•
Before any installation and repair, please do cut off the power supply.
•
For safety reasons, install the unit firmly to avoid injury and damage.
•
Do not cover the unit.
•
Do not touch the unit with wet hands or pull the power wire forcefully.
•
Please don’t connect the power supply or turn on the system before
installation.
•
Before switching on power, please make sure the mains lead is in good
condition.
•
Where the MAINS plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily
operable.
•
The system should be kept dry .Please don’t use the system in the
condition of rain, wet or dust. For indoor use only.
•
Do not turn on or off the system frequently.
•
Do not let it work continuously for an extended period of time. Turn off
the system for 25 minutes after running continuously for 3 hours.
•
Fixed Installation prevents the system from strong shaking or striking.
•
Prevent objects to get into the system, or there will be malfunction.
•
Leave at least 1m distance between the unit and other objects.
•
When transport the system again, please use the original package to
avoid shaking.
•
The user should comply with the instructions and warnings above. Any
damage, which is caused by incorrect operation or not following the
manual, is not covered by the warranty.
•
Be sure that there are no inflammable or explosive objects within 1.5m
distance.
•
Before installation, please make sure the power voltage matches the
system rated voltage.
•
Be sure that the fan and exhaust is not blocked.
Operation
Set the switch (7) to ON. Select AUTO or MUSIC controlled mode via the
switch (4). If you select music controlled mode, you can adjust the motor
rotation via the control (3).
For strobe mode, set the switch (7) to position 1. Stroboflash and adjust
the flash rate via the rotary control knob (6).
Set the switch (7) to OFF when you don’t use the laser anymore.
