MANUAL - COMBI-FX2
2
©Copyright LOTRONIC 2018
EN
INSTRUCTIONS FOR USE
4-IN-1 LIGHT EFFECT WITH ASTRO, WATERWAVE, UV & STROBE
Safety Recommendations
•
Please read the instructions carefully. They contain important information about the installation, operation and
maintenance.
•
Keep this User Manual for future reference. If you sell the unit to another user, be sure that he also receives this
instruction booklet.
•
Unpack and check the unit carefully that it has not been damaged during transport before using the unit.
•
Before operating, ensure that the voltage and frequency of power supply match the power requirements of the
unit.
•
The unit is for indoor use only in a dry location.
•
It is essential that the unit is earthed. Only connect to a wall outlet with earth connection.
•
The unit must be installed in a location with adequate ventilation, at least 0.5m from adjacent surfaces. Be sure
that no ventilation slots are blocked.
•
Disconnect mains power before fuse replacement or servicing.
•
Make sure there are no inflammable materials close to the unit during operation.
•
In the event of serious operating problem, stop using the unit immediately.
•
Never try to repair the unit by yourself. Repair carried out by unskilled people can lead to damage or malfunc-
tion. Please contact the nearest authorized technical assistance center and always use the same type of spare
parts.
•
Do not touch any wires during operation as high voltage might be causing electric shock.
•
The light source of this unit is not replaceable. If it is faulty, the unit must be discarded.
•
The product is for decorative purposes only and not suitable as a household room illumination.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
CAUTION
Do not open the housing
Shock Hazard
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the
unit is secure and able to support a weight of 10 times of the unit’s weight. Also always use a safety cable that
can hold 12 times the weight of the unit when installing the fixture.
The equipment must be fixed by professionals at a place where is out of the reach of people and where nobody
can pass by or under it.
Operation
•
The unit can work either automatically, follow the rhythm of the music via the built-in microphone on the rear
panel or be controlled via the supplied remote control.
•
Plug the unit into an appropriate mains outlet that supplies the required voltage for the unit.
•
Press the ON/OFF switch on the remote control.
•
Press the AUTO or SOUND button on the remote control or via the switch on the rear panel to select between
automatic or music controlled operation.
•
Increase /reduce sensitivity of music-controlled operation via the SEN+/SEN- buttons.
•
Press LED to activate the Astro light effect. Press to cycle through the colors red, green, blue, red-green, blue-
green, red-blue, color jump, color fade and strobe. Select the operating speed via the SPEED button.
•
Press LS button to activate the wterwave effect. Press to cycle through the indivdual colors (red, green,blue &
white), color combinations, color jump, color fade and strobe effect.
•
Press the UV button to switch on the black light.
•
Press FLASH button to activate the white strobe and increase the flash speed via the SPEED+/- buttons.
