Manual - STAR-LASER
4
©Copyright LOTRONIC 2021
a ground loop, and your fixture may perform erratically. Test cables with an ohm meter to check correct polarity
and to make sure the pins are not grounded or shorted to the shield or each other.
SETTING UP A DMX SERIAL DATA LINK
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the con
-
troller.
2. Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the
input connector of the next fixture consisting of a (male) 3 pin connector.
3. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.
MASTER/SLAVE FIXTURE LINKING
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first
fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the
input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from the
output as stated above to the input of the following fixture and so on
Often, the set up for Master-Slave and Stand-alone operation requires that the first fixture in the chain be initial
-
ized for this purpose via either settings in the control panel or DIP-switches. Secondarily, the fixtures that follow
may also require a slave setting. Please consult the '' Operating Instructions» section in this manual for complete
instructions for this type of setup and configuration.
NAVIGATION THROUGH THE CONTROL PANEL
Access control panel functions using the four panel buttons located directly underneath the LCD Display..
Button
Function
MENU
Used to access the menu or to return to a previous menu option
UP
Scrolls through menu options in ascending order
DOWN
Scrolls through menu options in descending order
ENTER
Used to select and store the current menu or option within a menu
When a menu function is selected, the display will show immediately the first available option for the selected
menu function. To select a menu item, press <ENTER>.
MENU MAP
Press the <MODE> button repeatedly until you reach the desired menu function. Use the <UP> and <DOWN>
buttons to navigate through the menu options. Press the <ENTER> button to select the menu function current
-
ly displayed or to enable a menu option. To return to the previous option or menu without changing the value,
press the <MODE> button. After a few seconds, the LED Display will switch off during operation until another
button is pressed.
Addr
d001-d512
512 address setting
CHnd
18CH
18 channel settings
13CH
13 channel setting
SLnd
Auto
Self running mode
Soun
Sound controlled mode
SHnd
SH 0
Effect 0 (recommended)
SH 1
Effect 1
SH 2
Effect 2
SH 3
Effect 3
SEnS
0-99
Voice sensitivity adjustment
LEd
OFF
Display off after 5 seconds of inactivity
ON
Display always on
dISP
no
Display reverse
YES
Display positive
UP
DOWN
MENU
ENTER
8.8.8.8.
