©Copyright LOTRONIC 2017
DJM160BT-MKII
4
9. POWER ON switch: turns on the MIXER. The LED will be on when the unit turns on.
10. CHANNEL 1 fader: adjusts the final channel volume.
11. Output Meter: Indicates the levels of left and right Master channels.
12. CHANNEL 2 fader: adjusts the final channel volume.
13/14. CUE button: allows you to monitor the music through the headphones for the selected channel.
15. MIC LEVEL control: adjusts the volume of the microphone signal.
16. The CROSSFADER is used to fade between channels 1 and 2.
17. The LEVEL control determines the volume of the headphones signal.
18. LCD screen
19. TIME: When the TIME function is activated, you can use the jog wheel to adjust the value of the X
parameter (time) of the effect generator.
20. RATIO: When the RATIO function is activated, you can use the jog wheel to adjust the value of the Y
parameter (mix ratio or resonance or feedback) of the effect generator
21. BY BASS: Press this button to choose or cancel DJ effects. When you press this button to choose the
DJ effects, DJ will be displayed. When you press this button again to cancel the DJ effects, BYPASS will be
displayed.
22. 16 DJ effects selector: You can choose among 16 DJ effects: Flanger, Flanger Verb, Phaser, Robot
Flanger, Pitch, Scratch, Analog Delay, Trans, PhaseWah, Filter, AutoWah, SmallHall, Thinplate, Plate, LPF
Reverb, Gated Reveb.
23 JOG WHEEL– This wheel has 2 functions:
In SCRATCH mode
Turn the Effect Selector to N0.6 Effect to activate the scratch function. While in Play mode you
can scratch the track with the Jog Wheel like a vinyl record
In PARAMETER mode
TIME BUTTON ( X parameter)
– When the TIME function is activated, you can use the jog Wheel to
adjust the value of the X parameter (time) of the effect generators.
RATIO BUTTON (Y parameter)
–When the RATIO function is activated, you can use the jog Wheel to
adjust the value of the Y parameter (mix ratio or resonance or feedback) of the effect generators.
24. The HEADPHONES socket allows you to connect your headphones for pre-listening (PFL signal). For best
results, use headphones with an impedance rating of at least 32 Ohms
25. The microphone connector is a balanced 1/4” TRS socket for microphone connection.
26. Channel 1 inputs: The LINE inputs may be used for connecting tape decks, CD or MD players etc
27. Channel 2 inputs. The LINE inputs may be used for connecting tape decks, CD or MD players etc.
28. Use the Master output to connect the unit to an amplifier.
In order to avoid power-up thumps, which can damage your loudspeakers, please power up your
amplifier last. There should be no signal present, e.g. no music playing, when you turn on your amp.
In addition, we suggest that you set all volume-related controls to “zero” (down) before powering up
your system. Following these precautions will save you from unpleasant and potentially dangerous
surprises.
29. Power supply: Only use the power adapter provided with the unit to power the unit. When connecting and
disconnecting the power cord, be sure the power of the unit is off. Connect the cord to the rear of the unit and
then connect it to the outlet.
30. BT antenna
31. Power Adaptor (Packed inside the box): AC12V, 500mA
