ibidi 12150, Инструкция по эксплуатации

Страница: 19 / 36

ibidi Heating System Multiwell Plate – Silver Line
4.3 ibidi Temperature Controller – Silver Line
The ibidi Temperature Controller – Silver Line is designed to precisely operate the different ibidi
Silver Line heating devices, including the Incubation Chamber Multiwell Plate – Silver Line. In total,
6 channels are available, each channel accommodating one heated component (e.g., the Heated Lid,
Heated Plate, and Heated Glass Bottom of the Incubation Chamber Multiwell Plate, which cover 3
channels). In addition, an external Temperature Sensor can be connected.
The front panel enables access to the Temperature Controller’s settings. The front panel display
shows the values of set (‘S’ = set) and actually measured (‘I’ = is) temperatures. The temperature set
values and other settings can be adjusted via the control buttons (Section
5.3 ).
If you wish to control the Temperature Controller via PC, use the IncuControl software (Section 6 ).
1
3
4
6
2 5
ibidi Temperature Controller
Plate
I 38.0
S[ 38.0]
Run
Lid Glass
42.1 36.9
42.0 37.0
Setup N.C.
1
Figure 6: Front view of the ibidi Temperature Controller – Silver Line.
The LEDs of the front panel indicate the status of the channels, connection to power supply, and USB
connection (Figure
6 ).
Control LEDs Channel 1–6
LED off Channel inactive
LED on Channel active
LED fast blinking Channel error
Please contact ibidi at
techsupport@ibidi.com .
All electrical connectors are located on the back of the Temperature Controller (Figure 7 ). For con-
necting the heating devices, two port sizes are available. The larger ports 1/2 and 4/5, which each
accommodate two output channels, and the smaller ports for the output channels 3 and 6. Please
find which heating units can be connected to which port in Table
4 (Section 5.3 ). Refer to Section 5.1
for setting up the ibidi Heating System Multiwell Plate.
Instruction Manual 19 Version 1.0 (August 1, 2022)