iBell OS23-46, Руководство оператора, Страница: 8 / 16

7

Do not use accessories which are not specifically designed and
recommended by the tool manufacturer.
Just because the
accessory can be attached to your power tool, it does not assure
safe operation.

Use special precautions when sanding chemically pressurized
timber, paint that may be lead based, or any other materials that
are highly dangerous to human. Work should be sealed by plastic
sheeting and persons not protected should be kept out until work
area is thoroughly cleaned.

Position the power supply cord out of rotating accessory. Do
not abuse the cord, never use the cord to carry the tools or pull
the plug from the outlet. Always make sure that any extension
cord you use is in good condition, and if used outdoors is of a
suitable type, and so labelled.

Use the vacuum dust extraction accessory in conjunction with
this sander.
The workplace should be kept as clean and dust free
as possible. Do not connect a domestic vacuum cleaner to this
machine.

Never lay the power tool down until the accessory has come to
a complete stop.
The rotating accessory may grab the surface
and pull the power tool out of your control.

Do not use a damaged accessory. Before each use inspect the
accessory such as abrasive discs for chips and cracks, backing
pad for cracks, tear or excess wear.
If power tool or accessory is
damaged, inspect for damage or install with a replaced accessory.

Threaded mounting of accessories must match the spindle
thread.
Accessories that do not match the mounting hardware of
the power tool will run out of balance, vibrate excessively and
may cause loss of control.

Be extremely careful of dust disposal, materials in fine particle
form may be explosive.
Do not throw sanding dust on an open
fire. Spontaneous combustion, may in time, result from a mixture
of oil or water with dust particles.

Always check the tool for damaged parts. Regularly clean the
power tool’s air vents.
The motor’s fan will draw the dust inside
the housing and excessive accumulation of powdered metal may
cause electrical hazards.
IBL OS23-46