IBC Water AS36700, Инструкция по установке и эксплуатации

Страница: 6 / 27

Page 6
EXAMPLE
The medium and maximum capacities of a single unit from Table 4 are 36000 and 49000
respectively. The calculated capacity falls closer to the maximum and so the higher value
should be used.
Salt dosage required per single softener for 36000 g is 90 kg (from Table 4).
Now looking at Table 5 we find that only wet salt can be used. However, when your
calculated salt dosage allows you the choice of either dry or wet salt always choose dry salt.
Install the brine valve as shown in Brine Tank Set-up.
The initial salt load as shown in Table 7 should be loaded into the brine tank.
IMPORTANT NOTE:
The water softener, as supplied, has the brine riser pipe assembled to suit dry salt
brine system. If, however, on reference to Table 5 you find that wet salt must be
used, then wet salt brine rise pipe (short black pipe piece supplied) must be fitted to
the brine valve.
Note : For wet salt it is very important that the salt level be maintained in line with the
brine valve. As illustrated in the brine tank setup sheet, the salt used per
regeneration must be replenished at least 4 hours before the next regeneration.