IBC control MicroMax180, Руководство пользователя, Страница: 93 / 192

10
Check that
the control unit is connected as per instructions on page 10.
Input voltage 230-240 V +/-15%, 50/60 Hz.
Check that the motor is wired for 3 x 230 V. If there is an operating switch between
the motor and the control unit, the motor thermal contact should be
connected via the auxiliary terminal in the operating switch.
Check that the input signal is 0-10 V .
Check that the cleaning function and rotation monitor DIP switch are set to ON.
Check that
the frequency DIP switch is set to 100 Hz for normal wheel speed
(10-12 rpm).
PUTTING THE EQUIPMENT INTO OPERATION
Should be done in sequence.
Check that the motor rotates in the right direction in relation to the wheel's direction
of rotation. In the event of a fault, switch two phases to the motor.
Adjustment of max.
speed
Set the High Speed DIP switch to the ON position.
Adjust "Max. speed" so that the wheel rotates at 10-12 rpm
(or as per directions from wheel manufacturer).
After a test run, set the DIP switch to OFF.
Checking minimum
speed
Set the Low Speed DIP switch to ON.
Check that the wheel starts.
The minimum speed is preset.
After a test run, set the DIP switch to OFF.
Checking the cleaning
function
Switch off the voltage.
Make sure the “Cleaning” DIP switch is set to ON and the input signal is
disconnected. When power is switched on, the wheel will rotate at
minimum rpm for 10 seconds.
Checking the rotation
monitor
The yellow Rotation LED will flash when the magnet passes the magnetic
sensor, regardless of DIP switch position.
Finish by
having the control unit drive the wheel at maximum and minimum
rotation speed and checking that the wheel speed is correct.
CHECKS BEFORE POWERING UP THE CONTROL UNIT
11