iBaby MonitorUser Manual
22
1) Is the base placed?
The temperature and humidity module is built into the magnetic base. The iBaby and the three
metal domes on the base should be aligned and placed flat. It is best to pick up the iBaby and
pick up the magnetic base.
2) Is the iBaby firmware version up to date?
APP Settings Menu - "Settings -" Device & Application Information page, confirm the firmware
version is 1.8.1 and above.
Question 6 How to reset the device (reset device to factory settings)?
Answer: Press and hold the RST button on the bottom of the device, don't let go, until the LED
status light in Figure 1 starts to flash red and flash alternately (more than one second), then you
can let go. When the music is ringing, and the LED light turns red slowly (one second), the reset
is complete.
5
Contact information
Customer service hotline
：
1-888-538-1004
（
Monday – Friday: 9 am – 5 pm PT
）
Website
：
https://ibabylabs.com
6
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC warning:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Содержание M2C
Страница 1: ...iBaby Labs Inc...