IBA MS8xICP, Руководство пользователя

Страница: 13 / 29

ibaMS8xICP Manual
Issue 1.7 13
7.2.2 Status of ICP inputs
The LED display is described with a gain of 0 dB by way of an example.
LED per channel Status/meaning Description for 0dB
(approx. values)
L26 … L33 Off No signal, signal
too low
± (0 V … 0.16 V)
Green Within measuring
range
± (0.16 V…4 V)
Yellow End of measuring
range
± (4 V …5 V)
Red Out of measuring
range
> ± 5 V
7.3 Analog inputs X1
Important note
It is typical for an ICP input, that a channel requires a settling time of about 10 to 50 sec-
onds after the gain factor was changed.
This also applies, if the signal was overdriven for a short time.
7.3.1 Input gain
The channel input gain can be adjusted per channel as follows:

0dB

6dB

12dB

20dB
7.3.2 Filter
There are the following filters per channel:
Filter type Order Cutoff
frequency
in addition /
permanent
R/C low-pass 1. 40 kHz permanent
Analog anti-aliasing Butterworth 4. 20 kHz permanent
Digital anti-aliasing filter*
(Tschebyscheff I)
8. can be adjusted
(100 Hz …
0.5*sampling rate)
in addition
(sampling rate
> 500 Hz)
* only with ibaPDA
Figure 2: Filter sections