ibaDAQ-C
Manual
Issue 1.4
25
9.2
ibaDAQ-C configuration
The following settings are made in the ibaDAQ-C node:
Configuration of the interrupt source, see chapter 9.2.1
Network settings of the device, see chapter 9.2.2
Firmware update and restarting the device, see chapter 9.2.2
User-defined signal assignment of the LEDs PDA1 and PDA2, see chapter 9.2.2
Connection of further modules and communication interfaces, see chapter 9.3.
9.2.1
Configuration tab
Figure 16: ibaDAQ-C – Configuration tab
ibaPDA uses only the ibaDAQ-C hardware as interrupt source. When "In use" is disabled,
ibaPDA uses the less accurate internal timer.
The illustration of the device displays the current state of the LEDs and the hex switch.
