ibaBM-DPM-S-64
Manual
Issue 2.5
39
You want to connect the device directly with your PC and the network adapter in
your PC is set to “Get IP address from DHCP server”.
After you have connected the device with the PC it takes approximately one minute
until the communication is established. Duri
ng this time you’ll see a message “get
network address” in the status field for the network connection on your PC. After,
you’ll also have access to the web interface of the device via Ethernet.
Tip
For a direct link between the device and your PC, i. e. without hub or switch, you
should use a cross-over Ethernet cable.
9.3.2
USB Interface
The USB interface is located on the bottom side of the device, too, and can also be
used for configuration data. The procedure is basically the same like described for the
Ethernet TCP/IP interface.
As soon as the PC or laptop computer is connected for the first time over the USB in-
terface by a standard USB cable (A/B), the “Found New Hardware Wizard” will show
up.
1.
Choose „No, not this time“ in the dialog box and click on <Next>.
2.
In the following dialog choose „Install from a list or specific location..“ and click on
<Next>.
