ibaBM-DIS-i-8o
Manual
Issue 1.2
17
6
Installation, Connection, Disassembly
6.1
Installation
1.
Insert the clip of the mounting rail fastened on the device into the mounting rail.
2.
Press the device down in such a way that the clip of the mounting rail engages with
a click.
6.2
Connection
1.
If it is stipulated for the system that the device must be grounded, connect it to earth.
2.
Connect the power supply. Observe the correct polarity.
3.
Connect the fiber optic cables to the inputs and outputs.
4.
If you have connected all the required fiber optic cables, switch on the device.
Note
The device will immediately switch into ready-for-operation mode. The LED L1 is blink-
ing.
During current operation you are able to perform operations on the device. The device
can remain switched on.
6.3
Disassembly
Note
If the power supply is interrupted, the device is no longer ready for operation. No LEDs
are lit up or blinking.
1.
Switch off the device.
2.
Disconnect the power supply.
3.
Disconnect it from the earth.
4.
Disconnect all FO cables.
5.
Close the open inputs and outputs with a cover.
6.
Hold the device to prevent it from falling down and press it slightly downwards.
7.
After that pull the device and lift it up. The clip of the mounting rail will disengage with
a click.
8.
Remove the device.
When storing or transporting the device observe the values specified in the chapter
“Technical data”.