Rev. 20220501
6
iArmor
®
Customer Support: [email protected]
b.
Line up the slots on the Support Brackets with the back of
the pinch weld. Mark the location of the slots onto the pinch
weld.
c.
Drill (2) 1/4” holes through the pinch weld for each Support
Bracket.
IMPORTANT
: Do not drill too close to the bottom edge of the
pinch weld. Adjust the Brackets as necessary to move the slots
up the body panel away from the edge. Drill the holes toward
the outside of the marked slots.
d.
Attach each Support Bracket to the pinch weld with (2) M6X1
-25 Hex Bolts, (4) M6 Large Flat Washers and (2) M6X1 Nylon
Lock Nuts,
(Fig 10)
. Check for level then fully tighten all hard-
ware.
STEP 7
Move to the other side of the vehicle. Repeat
Steps 1-6
to in-
stall the other side step bar.
Attention
Do periodic inspections to the installation to make sure
that all hardware is secure and tight.
In order to protect your bars/boards, please use mild
soap/non-abrasive products for cleaning only.
(Fig 13) Passenger Side Step Bar Installed
(6) M10X1.5-25 Hex Bolts
(12) M10 Flat Washers
(6) M10X1.5 Nylon Lock Nuts
Front
Bottom View
