Rev. 20220501
3
iArmor
®
Customer Support: [email protected]
The instruction here is for your reference only. We strongly
recommend the professional installer for best result. We are not
responsible for any damage caused by the installation.
STEP 1
Start installing from the passenger side front mounting location
of the vehicle, (Fig 1). Remove the sealing tapes covering the
oval hole and the hex holes on the body panel, if equipped.
(Fig
1)
.
Note: All (3) Mounting Brackets and (3) Support Brackets
for Passenger Side are universal. All (3) Mounting Brackets
and (3) Support Brackets for Driver Side are universal.
STEP 2
Determine the correct procedure to attach (1) Passenger Front
Mounting Bracket for your model/year:
Models without factory threaded inserts on body panel:
a.
Partially thread (1) M8X1.25-30 Hex Bolt into the welded
nut on (1) M8 Bolt/Nut Plate
(Fig 2)
. Thread the hex bolt in
until it is flush with the welded nut,
(Fig 3)
. Use the hex
bolt as a handle and insert the Bolt/Nut Plate into the oval
hole, feed the threaded bolt on the plate through one of
the hex holes,
(Fig 4)
. Thread (1) M8 Plastic Washer onto
the threaded end and down tight against the body panel,
(Fig 5)
.
NOTE
:
The Plastic Washer is designed to keep
Front
(Fig 1) Passenger Side Front Mounting Location
(No factory holes on pinch weld on some trims)
the Bolt Plate from falling into the body panel within
bracket installation.
b. Attach (1) Passenger Side Mounting Bracket to the
threaded end of the installed M8 Bolt/Nut Plate with (1) M8
Large Flat Washer, (1) M8 Lock Washer and (1) M8X1.25
Hex Nut,
(Fig 6).
c. Remove the M8X1.25-30 Hex Bolt from the welded nut on
the Bolt/Nut Plate. Rotate the Bolt/Nut Plate until the weld-
ed nut lines up with the other hole on the Mounting Brack-
et.
d. Secure the Passenger Side Mounting Bracket to the weld-
ed nut on the M8 Bolt/Nut Plate with (1) M8x1.25-30 Hex
Bolt, (1) M8 Lock Washer and (1) M8 Large Flat Washer
(Fig 6)
. Do not fully tighten hardware at this time.
(Fig 2) M8 Bolt/Nut Plate (NOTE: M8 Bolt Plate is
not required on models with threaded inserts)
(Fig 3) Thread M8X1.25-30 Hex Bolt into the weld-
ed nut on the plate
Flush
(Fig 4) Use the Hex Bolt as a handle. Insert the Bolt/Nut Plate
into the oval hole and feed the threaded end out either facto-
ry hex hole.
IMPORTANT: Do not remove the Hex Bolt until the Plastic
Washer is threaded onto the welded bolt (Fig 5).
Remove sealing
tapes if equipped
