IAG IDF6SE3, Инструкция по установке и эксплуатации

Страница: 7 / 23

5
Fill the detergent dispenser with detergent.recommended
for automatic dishwashers only.
The marking indicates the dosing levels , as Illustrated on right:
The area where the detergent is placed for main wash cycle,
“MIN”means approximately 20g of detergen.
The area where the detergent is placed for pre-wash cycle,
approximately 5g of detergent
Please observe the manufacturers dosing and storage
recommendations as stated on the detergent packaging.
Close the lid and press until it locks in place.
If the dishes are heavily soiled, place an additional detergent dose in the pre-wash detergent
chamber. This detergent will take effect during the pre-wash phase.
You find information about the amount of detergent for the single programmes in the table
on page 10. Please be aware, that according to the level of soiling and the specific hardness of
water, differences are possible.
Please observe the manufacturer's recommendations on the detergent packaging.
Detergents
There are 3 sorts of detergents
1.With phosphate and with chlorine
2.With phosphate and without chlorine
3.Without phosphate and without chloride
Normally new pulverised detergent is without phosphate. The water softener function of
phosphate is not given. In this case we recommend to fill salt in the salt container even when
the hardness of water is only 6 dH. If detergents without phosphate were used in case of hard
water often white spots appear at dishes and glasses. In this case please add more detergent
to reach better results. Detergents without chlorine do only bleach a little. Strong and coloured
spots will not removed completely. In this case please choose a programme with higher
temperature.
NOTE:
1
2
Filling detergent dispenser