IAG Performance | 1203 Baltimore Blvd. Westminster, MD 21157 | Ph: 410-840-3555 | www.iagperformance.com
4
8. Place the acorn nut on the back side. First tighten the
ball joint with a ½” wrench then tighten the acorn nut with
a ½” wrench.
8.
9. Make sure the wastegate is completely shut and adjust
the turnbuckle so the rod end is aligned with the
wastegate arm. Place the 8mm bolt through the rod end
and wastegate arm and screw the copper nut on the
bottom and tighten with a 6mm allen and 12mm wrench.
9.
10. Slightly loosen the turnbuckle so there is no tension on
the linkage. Rotate the bracket so the linkage is
perpendicular to the bracket. Use your 4mm ball head
allen to tighten the bracket to the compressor housing.
Tighten the turnbuckle with your ½” wrench until the
wastegate is shut and linkage is tight. Now tighten the jam
nuts against the turnbuckle to prevent the turnbuckle
from loosening.
Your factory wastegate is now shut.
10.
